Mounting Kit - Select Chemicals Limited

Go to content

Main menu:

Information
Mounting kit 



      

   



After deciding where to install the unit, attach the wall bracket. Put the top screw in first.

If attaching it to a concrete wall drill a 6mm hole 30mm deep. Insert the rawl plug, place the hole over the plug and screw in the screw with the counter sunk head. If attaching it to a wooden substrate drill a 3mm hole 20mm deep.

Tighten the screw so it is firm. Level the bracket and mark the wall through the slot where to drill the other hole.

Swing the bracket to one side and drill the second hole.

Swing the bracket back into place, slip the washer onto the pan head screw and screw it in.

Check the bracket is level and tighten both screws.

The mounting bracket attached to the back of the enclosure slots over the wall bracket. Press down firmly on the top of the enclosure so the latch at the top of the wall bracket locks into place and stops the unit from being accidently dislodged.

To remove the unit, gently press the latch back with screw driver and nudge the enclosure up. It does not have to moved up far so be careful not to drop it.


Require further information, product booklet or a safety data sheet.
e-mail or call us.
 
 
 
 
Back to content | Back to main menu